Artificial Atoms: As they relate to Quibits.

So far they’re using a single electron artificial atoms in quantum wells to become quibits. 

From what I’ve found in my lazy search they seem to think that quitrits and quadtrits are the maximum number of artificial trits that can be made since 2013—but that is incomplete.

The standard deviation of an atom is a nucleus wrapped around with electrons who travel in patterns around the nucleus in a wave/formed pattern. 


Thought experiment to get to the next point:

If you let a single atom float in a vacuum full of super fluid (assuming no possible bonds able) denying gravity’s hold on the density and mass of the atom, and the superfluid pushing against all parts of the atom at once dependent on the superfluids movement. Other than if we’re lucky enough to have stabilized superfluid after some time—inherent vibration withstanding. Would we be able to find the sole atoms exact electron travel within the confines. If so could we then release that atom in this fluid so that is it constantly “falling or rising” dependent on the superfluids movement around it. Depends on the containers shape. A single tube gives up. A s bend on it’s end middle gives down if from the proper side.  

So that we can then “open” an area where the electrons are centralized within a halo around the “top” or “bottom” of the sole atom. That would open up many stages to insert wavelengths  from within the containers walls or outside it if properly managed other than radio at once and change the planes that would be interacted to be actable more than singularly at once, so that you could actually hit one electron, infer it’s superimposed cousin from glimmering from the initial hit not the same as the other electrons and then the general direction of the superposition atoms direction outside the container. This may have to be done in a completely dark room. Dual vacuumed enclosure/dual superfluid to allow clarity. And if so would it be possible to set this example up twice, in either the same state or two opposing states so that you get that glimmer and can start to literally determine superpositions distance/locations.

At the same time we could do a different function where we hit multiple electrons at once causing them to pulse in ways we want—up, down, side to side, diagonal and since the electrons of the sole atoms are compressed between the superfluids electrons, if we time them, we could bounce from one atom to the other and back again, bending the super position—though technically not that—a new form of some kind (atomic J Hook?), around the same atom either the other side of the same electron or a cousin electron within the halo. From there we take all possible iterations of those atoms and wavelength iterations and we can build a table/dataset of superposition distances or at the least their angles. Knowing that by raising the superfluid temperature using light would possibly change it’s state we would have to start small with the lowest coolest lights possible. Or diffusion through a material to slow it down to it’s coolest speed though through a final lens to hit it’s target. Read speed isn’t important at first, it’s just the fact that we can figure out the change states in real time. 

Hot Quibits:


There is such a thing as multi layered super positioning when using light’s wavelengths at the medium of super positioning.

You can cut the points of contact around the nucleus so that they create multi cast shadows where they are cross referenced. You can still read the bits themselves, but also the references as other operations. Or at least as another set of information, be it topographical or depth-wise. 

Eventually you’ll be getting “hot” chipsets that can handle the cooler frequencies in tandem when pulsed with slightly higher frequencies, and when they mix you’ll get another set. Interspersing them between the atoms means you’ll get an array of data from one series of quantum pulses, but they can be interconnected in such a way as to be read from any side as warranted as long as you want to read those cross references. You can then focus those wave lengths into something else using prisms or whatever is new nowadays in lens technologies.

You can also build materials to absorb the cross references and hold them as heat.

There is a possibility to create cool and hot well combination boards that let you do both functionalities at once in one pass and as they become warmer and the cool becomes raised you flip the tech and cool the hot quibits to be cool and then you have a on/off action as well as a cool warm cycle needed to disperse heating massive racks of of quantum chipsets built in. Such as they do now with quantum dots. Though I know those range in size instead, these would range in temperature or frequency reception until they hit a critical array and then an interpreter function would change it to the opposite or reproduce the cooling function in the same spot in waves so you don’t lose information and can “Store” it as you would—so quantum Dram. But light is the way to go here.

To create Quantum Sram You would need to spin the materials down to a certain cool point then keep them at a temperature considered stable and that would keep the spin if not adjusted static creating a range of Sram. Perhaps you would need a certain atom type that spins slowly against a certain lights frequency constantly, wobbles very little to not at all.

You know what if you capture the atom with a carbon shell as I described this morning and then pulsed it within the solution so that it span slowly as it was at it’s coolest and it was in a vacuum so that it couldn’t run up the side of the wall, and only allowed entry of the lights through  the carbide rings insulating the tetrahedral diamonds through focussing lenses you could get very “slow” read speeds, meaning they would have time to spin down to “static” and then you could repeat and that would also be your storage read speed. 

Quantum computers using photons and electrons.

Quantum computers using photons and electrons.

Photons have spin-1, electron 1/2. Meaning you could condense the number of way electrons at certain speeds and qutrits by using photons to cancel out the spin of unneeded number increasing output speed. At least for spun waves.

Wikipedia.

Quantum entanglement means there would be a -1/2, +1/2 electron spin. If a proton was spun at it +1 it would become 1/2 and +1.5 for the +1/2, while a quantum entangled proton with -1 become -1.5, -1/2. Meaning you could divert three +/-1 times the number of electrons into the proton entanglement getting up to 4 times the output (certainty of randomness?) As the single entanglements would negate to zero or be interfered again with light.

Would it also mean that if the entangle particles collapsed before the photon affected ones did you would lose the effect of their interaction or would the new state remain constant to become something useable as a boundary box for the qubit and qutrits inside?

Especially if you combine layering of qutrits and qubits.

Couldn’t you arrange the three in staggered stages so that as they collapse in their given direction the peaks combined with the spun protons carry information further into the system juicing the qubits and qutrits much further than pure quantum entanglement.

Need to learn about the Bell states more. And Not gates.

Quantum connection (not all gates shown). I realised I forgot some negative signs. I was thinking of this as a layer in a multilayered stack offset to each other diagonally around the center 1.5/-1.5.

So this doesn’t include all not gates drawn nor regular gates drawn but to give an idea of what photons could do increasing the spin of an electron without being an electron spun up to light speed (cooling advantage. May be able to run off new leds). But we have

14 1.5 transactions. (1/2, -1.5, -1/2, +1/2)

12 1/3 transactions. (1 1/3, -2/3, -1/3, +1/3)

56 1/2 transactions. (28 1/2, 28 -1/2)

Of which the

1.5, 1.3, 2/3, 1/3, 1/2 positives also have

-1.5, -1.3, -2/3, -1/3, -1/2 negatives.

Some of bonds are due to quantum entanglement and could create new reversible and non reversible gate types as well as length the entanglement between bits as they are produced.

Then again couldn’t quantum dots be shown down through a material to not expend as much heat and you run it off various leds types and it’s a room temperature quantum computer.

Wikipedia.

Quantum dot gets excited and releases electron into conductance band first into the system to get electron spin then lowered back to valence band to get (with uv help) emitting light so you can get different size quantum artificial atoms as well as colors for emittance. Multilayered quantum computing at the true speed of quantum dots light limited by uv pulse output.

Just an idea.

-J.