Ideas on quantum computing. Spiral quantum computer. Cross index 3-d. Solid or superfluid oxygen low loss fast switching optical switch (radial).

These are all just ideas I’ve had over the past few days while I can’t sleep or am bored.

Set up the connections between electron joints so that parallel connections pattern predictably once mapped.

Image 1

You do this by applying rings of electrons fast enough but not overbearing around Atoms until you find their wave functions.

Then you join them.

Then their rotational points are juiced and patterned. Cross index in 3-d. And you get a matrix for full computation within a finite space. Using atoms with differing wave functions gives you depending on whether you want to get past qubit measurements and get into the next area after that by superimposing vastly more options of travel and spin then you’ll see that not only does it go side ways and up but backwards and down as well. Start from the center or not. It just changes the speed of retaliation and production against the boundaries.

Then you can get patterns within patterns. Fractal states of information as collisions occur and you build higher function math from them.

Quantum computer uses light. Photons.

Ultra fast low loss optical switching.

Mass of a proton:

electron mass / 1836 =

4.96153789 × 10-34 kilograms


4.96153789 * (10^(-34)) kilograms =

4.96153789 × 10^-19 picograms

1 picogram [pg] = 602213665167.52 Atomic mass unit [u]

Carbon 12.0107 u = 7.2330077e+12 pg

Oxygen 8 u = 4.8177093e+12 pg

You’d have a pyramid of carbon with an atom of oxygen fullerene in the center as an optical switch reinforced outside from the temp so there’s only needed size for photon transmission. Heat cool the inside to keep it change state between solid aNd liquid or just solid.

If solid it’s blue—supposedly best colour being the coolest. It’s easily space stable but may burn out unless super fluid. But you could lattice it as a liquid and freeze it using carbon as the cooling agent to get below superfluid state becoming optically superclear as long as the fullerene pyramids are secured and wrapped in tape or foil to not over expand and keep fluid stably inside container. But -455 is 22 times ish larger than their earth size. So you’d make crystal lattices of solid oxygen and focus the beams as well as build switching beams.

So not tiny but not huge either. 170 x 22 1700 3400 3740 pm. Per carbon. Times two 7480 pm. .007480 microns.

Oh no you wouldn’t. You’d do a radial encompassing of carbon. Not a pyramid unless tiny focus is needed. Radial allows tubular bonds and liquid oxygen superfluid construction around any angle.

Radial design.

Image 2

Audio transcript:

So with the electrons of liquid oxygen cooled to the level of space which I think is negative 400 degrees so that’s at least minus 200 kelvin. So that make that a solid. You line up the electron points. Where they bond and those are your focal points. For the uh low loss high precision light switch and you can get a directional one by cycling the speed of the electron spin as they’re bonded because as they slow down because they’re a solid I don’t know if they’re going to stop or not or if they would,but you’d measure the cycle of number eight is bailable for this number of micro seconds and then it goes 7 dead (or less depending on bit rate) and then 8 again and it’ll carry it so you just ping it on number 8 it carries it around and pings it to the next part and if you wanted to you could ping it continuously all the valence electrons for oxygen or however many are avail label in the build which I think there are 2 since it’s a single atom build easier and less fractal but you could easily add more. It’s a lot of time. Once you do the timing you should be good really.

You could double bond 3 of the carbon from the oxygen and have 4 times the connection speed. It depends on what you want.

If atomic clocks can measure the state of electrons jumping 1/1836 times that will measure the speed of a photon over some distance. Assume C. Electron is 2200 km /sec /1836= 1.19825708061 so we know that the distance traveled is roughly 1.2 kilometers away so you’d have a receiver there. Node system. entanglement is roughly useful because you can have non entangled and entangled as 1/0 and as long as placement is correct they should start computing relative to outside forces. Does an entangle particle hitting another entangled particle make a quad or does it split it into four single lower states. Do the states become additive or are they reversing between each other.

You just build receivers that can take both types in either state fired from either an array a cube or sphere to and encompassing shape of a larger size that lets you translate the material into knowable mathematics.

From there if you can get change states between entangled and non that travel the same distance to be received you can create higher order math functions.

Can you Tri split a photon. Yes. Can a photon be split into it natural seven or so states of light waves. All of those are information schema. Or mathematical languages/operators if you want to base them off of straight photon is 1/0. It’s just a matter of figuring out the distances needed to travel to receive and translate. Then you take those early examples and speed them up to shorten the distance until you get any size ( high heat) photon receiving you want. But blue is probably easiest. Perhaps the liquid oxygen optical switch will help. Then you build solid optical switches in each wave length and each receiver ship, likely different distances based on wave function until you get them small enough.

Easiest way to do this is to build them on stands (rural or on top of buildings) that have no interruptions within their path, or the ability because light refracts on mass to aim it as needed. You’ll lose packets if you hit a bird, clouds or smog. Any diffusion. I wonder what the accuracy if teleportation was within. Which boundary. Probably classified.

Image 3
Image 4


Image 5

F function determined by wavelength depth, speed. Position relative to others in series until we reach f alpha or the function asked for. Refraction plays a big part in this too.

Transmission both forwards and backwards. Hits wave length. Gather wavelength at specific point. Determine value by mapping wave lengths values in physical space as numerical weights or as percentages or what have you–some operator through the deterministic material. Wave length can continue or stop but it comes into contact with receiving layer or the function layer which accepts the photon and creates a value. Continues southward until all functions and types of functions are determined.


This is what I’ve got so far. I don’t know if it will work but it’s what I would try to see what happens.

Edit 1/29/19:

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s